Category: Undervogn
Scale:
Plug:
Volt:
Surface:
Description
The RPM70192 Rear A-arms for the Associated Rival MT8 are specifically designed to enhance durability and withstand more than stock A-arms. If you're looking for a reliable upgrade to strengthen your vehicle, these A-arms are the ideal choice.
Extra Material for Enhanced Durability
RPM has improved the design of the rear A-arms by increasing the amount of material around the inner hinge pins by 7% and widening this diameter by nearly 40%. At the outer hinge pins, material volume has been increased by 28% with an additional 9% width. These reinforcements allow your A-arms to withstand greater stress, reducing the risk of damage.
Reinforced Support Beams
RPM’s support beams on these A-arms are beefier than stock. While standard arms often taper at both ends, reducing thickness by up to 30%, RPM's A-arms maintain a consistent thickness of 12.7mm over nearly their entire length. Only at the inner hinge pins is there a slight taper to 11.43mm to match standard measurements. To compensate, RPM uses four massive support beams, making these A-arms the most durable alternative available.
Nearly Indestructible Nylon Material in Black and Blue
The RPM70192 Rear A-arms are made from RPM’s nearly indestructible, engineering-grade nylon blend, providing long-lasting durability. Available in both black and blue, you can customize your vehicle's look while gaining extra resistance to wear and impact.
Technical Notes & Compatibility
The RPM70192 Rear A-arms come in pairs and replace the stock Associated A-arms (#25911). For a full upgrade, it is recommended to also check out RPM70202 Front A-arms for the Associated Rival MT8.